make docker work

board/raspberrypi5_custom/config.txt

@@ -3,15 +3,12 @@
 
 kernel=Image
 
-# To use an external initramfs file
-#initramfs rootfs.cpio.gz
-
 # Disable HDMI to reduce noise
 hdmi_ignore_hotplug=1
 hdmi_blanking=2
 disable_splash=1
 
-# gpu mem config (seems to be totally nececcarry - smaller than 32m does not boot on rpi3)
+# gpu mem config (seems to be totally necessary - smaller than 32m does not boot on rpi3)
 gpu_mem=32
 
 # uart debug enable on GPIO14/15

configs/raspberrypi5_custom_defconfig

@@ -23,13 +23,19 @@ BR2_PACKAGE_XZ=y
 BR2_PACKAGE_RPI_FIRMWARE=y
 BR2_PACKAGE_RPI_FIRMWARE_CONFIG_FILE="$(BR2_EXTERNAL_AURACASTER_SYSTEM_PATH)/board/raspberrypi5_custom/config.txt"
 BR2_PACKAGE_RPI_FIRMWARE_CMDLINE_FILE="$(BR2_EXTERNAL_AURACASTER_SYSTEM_PATH)/board/raspberrypi5_custom/cmdline.txt"
-# BR2_PACKAGE_RPI_FIRMWARE_INSTALL_DTB_OVERLAYS is not set
+BR2_PACKAGE_RPI_FIRMWARE_INSTALL_DTB_OVERLAYS=y
+BR2_PACKAGE_OPENSSL=y
+BR2_PACKAGE_CA_CERTIFICATES=y
+BR2_PACKAGE_NETDATA=y
 BR2_PACKAGE_DROPBEAR=y
+BR2_PACKAGE_DOCKER_CLI=y
+BR2_PACKAGE_DOCKER_COMPOSE=y
+BR2_PACKAGE_DOCKER_ENGINE=y
 BR2_PACKAGE_KMOD=y
 BR2_PACKAGE_KMOD_TOOLS=y
 BR2_TARGET_ROOTFS_EXT2=y
 BR2_TARGET_ROOTFS_EXT2_4=y
-BR2_TARGET_ROOTFS_EXT2_SIZE="120M"
+BR2_TARGET_ROOTFS_EXT2_SIZE="512M"
 # BR2_TARGET_ROOTFS_TAR is not set
 BR2_PACKAGE_HOST_DOSFSTOOLS=y
 BR2_PACKAGE_HOST_GENIMAGE=y

flash_sdcard.sh

@@ -176,10 +176,6 @@ eval "$FLASH_COMMAND"
 # Sync to ensure all writes are complete
 sync
 
-echo
-echo "Flash complete!"
-echo
-
 # Remind user to eject the card safely
 echo "Flash complete!"
 echo
@@ -194,7 +190,6 @@ echo
 # Instructions for next steps
 echo "1. Insert the SD card into your Raspberry Pi 3"
 echo "2. Power on the device"
-echo "3. Access the SWUpdate web interface at http://<raspberry-pi-ip>:8080"
 echo
 
 exit 0