# Hardware Test Configuration

audio:
  sample_rate: 44100
  channels: 2
  device_name: "Scarlett"  # Will auto-detect Focusrite Scarlett
  
test_tones:
  frequencies: [100, 250, 500, 1000, 2000, 4000, 8000]  # Hz
  duration: 10.0  # seconds per frequency
  amplitude: 0.5  # 0.0 to 1.0
  latency_runs: 5  # Number of latency measurements to average

output:
  results_dir: "test_results"
  save_plots: true
  save_raw_audio: false

artifact_detection:
  test_frequency: 1000  # Hz - Test tone frequency (for sine wave mode)
  duration: 60.0  # seconds - Recording duration
  amplitude: 0.5  # 0.0 to 1.0
  startup_delay: 0  # seconds - Wait before starting recording to let system settle
  # Chirp signal parameters (used when --signal-type chirp is specified)
  chirp_f0: 100  # Hz - Chirp start frequency
  chirp_f1: 8000  # Hz - Chirp end frequency
  # NOTE: All detectors skip the first and last 1 second of recording to avoid startup/shutdown transients
  detectors:
    spectral_anomaly:
      enabled: false  # DISABLED - generates too many false positives, needs better algorithm
      threshold_db: -60  # Detect unexpected frequencies above noise floor + this threshold (more negative = less sensitive)
    amplitude_spikes:
      enabled: true
      threshold_factor: 5.0  # MAD-based outlier detection on envelope (detects clicks, pops, dropouts). Lower = more sensitive.
    zero_crossing:
      enabled: false
      threshold_factor: 2.0  # Number of standard deviations for zero-crossing anomalies (detects distortion)
    energy_variation:
      enabled: true
      threshold_db: 6.0  # Energy change threshold in dB between consecutive windows (detects level changes)

latency:
  max_std_dev_ms: 0.5  # Maximum allowed std deviation; test fails if exceeded
  min_avg_ms: 1.0      # Minimum expected average latency; near-zero indicates bad loopback

latency_buildup:
  measurement_interval: 10  # seconds between latency measurements
  max_duration: null  # maximum test duration in seconds (null = run until canceled)
  buildup_threshold_percent: 5.0  # percentage change threshold for buildup detection