Move TCL script files -- Step 1 of 2:

- Move src/target/{interface,target,board,test}/ into src/tcl/
- Remove existing rules in src/Makefile.am and src/target/Makefile.am.
- Add Makefile.am handling of *.cfg and *.tcl files in top Makefile.am:
  - Add dist-hook to include such files under src/tcl in the distribution.
  - Add install-data-hook to install contents of '$(top_srcdir)/src/tcl/'.
  - Add uninstall-hook to remove the installed script files.
- Change paths to (un)install script files in '$(pkgdatadir)/scripts'.


git-svn-id: svn://svn.berlios.de/openocd/trunk@1918 b42882b7-edfa-0310-969c-e2dbd0fdcd60

src/tcl/board/x300t.cfg

@@ -0,0 +1,30 @@
+# This is for the T-Home X300T / X301T IPTV box,
+# which are based on IPTV reference designs from Kiss/Cisco KMM-3***
+#
+# It has Sigma Designs SMP8634 chip.
+source [find target/smp8634.cfg]
+
+$_TARGETNAME configure -event reset-init { x300t_init }
+
+# 1MB CFI capable flash
+# flash bank <driver> <base> <size> <chip_width> <bus_width>
+flash bank cfi 0xac000000 0x100000 2 2 0
+
+proc x300t_init { } {
+	# Setup SDRAM config and flash mapping
+	# initialize ram
+	mww 0xa003fffc 3
+	mww 0xa003fffc 2
+	mww 0xa0030000 0xE34111BA
+	mww 0xa003fffc 0xa4444
+	mww 0xa003fffc 0
+	
+	# remap boot vector in CPU local RAM
+	mww 0xa006f000 0x60000
+	
+	# map flash to CPU address space REG_BASE_cpu_block+CPU_remap4
+	mww 0x0006f010 0x48000000
+	
+	# map flash addr to REG_BASE_cpu_block + LR_XENV_LOCATION (normally done by XOS)
+	mww 0x00061ff0 0x48000000
+}