tcl/target/rp2350: workarounds for ROM API issues

A0 chip: remove pad isolation
A2 chip: instead of reset init fixes we will fix the flash driver
with the following patch by Luke Wren:
8729: flash/nor/rp2xxx: fix flash operation after halt in RISC-V bootsel
https://review.openocd.org/c/openocd/+/8729

I don't have A1 version to test.

Signed-off-by: Tomas Vanek <vanekt@fbl.cz>
Change-Id: I9e9fab04ead929fe6e0a17c6c2f32a6f02e9beb9
Reviewed-on: https://review.openocd.org/c/openocd/+/8450
Tested-by: jenkins

tcl/target/rp2350.cfg

@@ -94,8 +94,7 @@ if { [info exists _TARGETNAME_RV0] } {
 	target create $_TARGETNAME_RV0 riscv -dap $_CHIPNAME.dap -ap-num 0xa000 -coreid 0
 	$_TARGETNAME_RV0 riscv set_enable_virt2phys off
 
-	# Workaround for stray IO_QSPI: GPIO_QSPI_SD1_CTRL: INOVER bit in RISC-V BOOTSEL
-	$_TARGETNAME_RV0 configure -event reset-init { mww 0x4003002c 0 }
+	$_TARGETNAME_RV0 configure -event reset-init "_rv_reset_init"
 
 	if { [info exists _TARGETNAME_CM0] } {
 		# just for setting after init when the event become-available is not fired
@@ -204,3 +203,22 @@ if { $_RESCUE } {
 	init
 	rescue_reset
 }
+
+proc _rv_reset_init { } {
+	set chip_id [format 0x%08x [read_memory 0x40000000 32 1]]
+
+	# Version related workarounds
+	switch $chip_id {
+		0x00004927 { # A0
+			# remove IO_QSPI isolation
+			mww 0x40030014 0
+			mww 0x4003001c 0
+			mww 0x40030024 0
+			mww 0x4003002c 0
+			mww 0x40030034 0
+			mww 0x4003003c 0
+		}
+	}
+
+	rp2xxx rom_api_call FC
+}