TCL: Add board file for EVALSPEAr300

Initial support for SPEAr300 chip and for evaluation
board named EVALSPEAr300.
Currently supports only those parts in common with
SPEAr310.

Change-Id: I8075aa721cf3dfaac561ee51e5df4ce9a2992e3e
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
Reviewed-on: http://openocd.zylin.com/230
Tested-by: jenkins
Reviewed-by: Spencer Oliver <spen@spen-soft.co.uk>

tcl/board/spear300evb_mod.cfg

@@ -0,0 +1,26 @@
+# Configuration for the ST SPEAr300 Evaluation board
+# EVALSPEAr300 Rev. 1.0, modified to enable SRST on JTAG connector
+# http://www.st.com/spear
+#
+# List of board modifications to enable SRST, as reported in
+# ST Application Note (FIXME: add reference).
+# - Modifications on the top layer:
+#    1. replace reset chip U4 with a STM6315SDW13F;
+# - Modifications on the bottom layer:
+#    2. add 0 ohm resistor R10. It is located close to JTAG connector.
+#    3. add a 10K ohm pull-up resistor on the reset wire named as
+#       POWERGOOD in the schematic.
+#
+# The easier way to do modification 3, is to use a resistor in package
+# 0603 and solder it between R10 and R54:
+# - one pad soldered with the pad of R54 connected to 3.3V (this
+#   is the pad of R54 far from JTAG connector J4)
+# - the other pad soldered with the nearest pad of R10.
+#
+# Date:      2011-11-18
+# Author:    Antonio Borneo <borneo.antonio@gmail.com>
+
+
+# Modified boards has SRST on JTAG connector
+set BOARD_HAS_SRST 1
+source [find board/spear300evb.cfg]