- jtag_khz/speed are now single parameter only. These are used

from pre/post_reset event scripts. Adding the second parameter was
a mistake seen in retrospect. this gives precise control in post_reset
for *when* the post reset speed is set. The pre_reset event was
added *after* the second parameter to jtag_khz/speed
- the target implementations no longer gets involved in the reset mode
scheme. Either they reset a target into a halted mode or not.
target_process_reset()
detects if the reset halt failed or not.
- tcl target event names are now target_N_name.  Mainly internal
at this early stage, but best to get the naming right now.
- added hardcoded reset modes from gdb_server.c. I don't know precisely what
these defaults should be or if it should be made configurable. Perhaps some
hardcoded defaults will do for now and it can be made configurable later.
- bugfix in cortex_m3.c for reset_run_and_xxx?
- issue syntax error upon obsolete argument in target command instead of
printing message that will surely drown in the log

git-svn-id: svn://svn.berlios.de/openocd/trunk@849 b42882b7-edfa-0310-969c-e2dbd0fdcd60

src/helper/command.c

@@ -346,6 +346,7 @@ int run_command(command_context_t *context, command_t *c, char *words[], int num
 	if (!((context->mode == COMMAND_CONFIG) || (c->mode == COMMAND_ANY) || (c->mode == context->mode) ))
 	{
 		/* Config commands can not run after the config stage */
+		LOG_ERROR("Illegal mode for command");
 		return ERROR_FAIL;
 	}