With this commit we add tcl files which describes
ARCv2 architecture features and configure files
for ARCv2 EMSK board.
Changes since v1:
-Moved from http://openocd.zylin.com/#/c/5332/4
into separate commit.
Changes:
22.01.2020:
-Removed "actionpoints" handling code in
tcl/cpu/arc/v2.tcl because this capability
is not supported yet.
Changes:
17.03.2020:
-Update Licence headers
-Cleanup indents
-Removed "reset halt" in boards .tcl
-Updated adapter frequency commands
Changes:
15.03.2020:
-Removed "init" in the of boards .tcl
Change-Id: I51bf620abe7b8e046e1dccc861a7d963965d3a42
Signed-off-by: Evgeniy Didin <didin@synopsys.com>
Cc: Alexey Brodkin <abrodkin@synopsys.com>
Reviewed-on: http://openocd.zylin.com/5350
Tested-by: jenkins
Reviewed-by: Oleksij Rempel <linux@rempel-privat.de>
Prerequisites:
The users of OpenOCD as well as computer programs interacting with OpenOCD are expecting that certain commands
do the same thing across all the targets.
Rules to follow when writing scripts:
1. The configuration script should be defined such as , for example, the following sequences are working:
reset
flash info <bank>
and
reset
flash erase_address <start> <len>
and
reset init
load
In most cases this can be accomplished by specifying the default startup mode as reset_init (target command
in the configuration file).
2. If the target is correctly configured, flash must be writable without any other helper commands. It is
assumed that all write-protect mechanisms should be disabled.
3. The configuration scripts should be defined such as the binary that was written to flash verifies
(turn off remapping, checksums, etc...)
flash write_image [file] <parameters>
verify_image [file] <parameters>
4. adapter speed sets the maximum speed (or alternatively RCLK). If invoked
multiple times only the last setting is used.
interface/xxx.cfg files are always executed *before* target/xxx.cfg
files, so any adapter speed in interface/xxx.cfg will be overridden by
target/xxx.cfg. adapter speed in interface/xxx.cfg would then, effectively,
set the default JTAG speed.
Note that a target/xxx.cfg file can invoke another target/yyy.cfg file,
so one can create target subtype configurations where e.g. only
amount of DRAM, oscillator speeds differ and having a single
config file for the default/common settings.
435e6101c6