Files
openocd/tcl/file_renaming.cfg
Nishanth Menon 19f5e20715 tcl/board/ti_beagle* move to board/beagle/ folder
Move the BeagleBoard.org Foundation boards to it's own folder. This
allows additional support such as BeagleV-Fire and other non TI SoC
vendor support to be subsequently added.

While doing this,
* Use "-" as separator for the file names as recommended
  by coding standards.
* To maintain compatibility, add the non-trivial renames to
  file_renaming.cfg

Change-Id: Ie916c9bf81fc3922bf19ed9ed2db841549d29ca9
Suggested-by: Antonio Borneo <borneo.antonio@gmail.com>
Signed-off-by: Nishanth Menon <nm@ti.com>
Reviewed-on: https://review.openocd.org/c/openocd/+/9204
Reviewed-by: Antonio Borneo <borneo.antonio@gmail.com>
Tested-by: jenkins
2025-12-13 17:20:05 +00:00

30 lines
1.3 KiB
INI

# SPDX-License-Identifier: GPL-2.0-or-later
# This file is used to remap configuration files that has been
# renamed, except simple renames that are taken care automatically
# like:
# .../file.cfg ==> .../${vendor}/file.cfg
# .../vendor-file.cfg ==> .../vendor/file.cfg
# .../vendor_file.cfg ==> .../vendor/file.cfg
#
# The formatting below is a TCL dict, so pairs of key-value
# in a simple TCL list, using for each line
# old_name new_name
# including in each name one of the prefix folder between
# board, chip, cpld, cpu, fpga, interface, target, test, tools
set _file_renaming {
board/nordic_nrf51822_mkit.cfg board/nordic/nrf51822-mkit.cfg
board/nordic_nrf51_dk.cfg board/nordic/nrf51-dk.cfg
board/nordic_nrf52_dk.cfg board/nordic/nrf52-dk.cfg
board/stm32mp13x_dk.cfg board/st/stm32mp135f-dk.cfg
board/stm32mp15x_dk2.cfg board/st/stm32mp157f-dk2.cfg
board/sifive-hifive1-revb.cfg board/sifive/hifive1-rev-b.cfg
board/ti_beagleboard.cfg board/beagle/beagleboard.cfg
board/ti_beagleboard_xm.cfg board/beagle/beagleboard-xm.cfg
board/ti_beaglebone_black.cfg board/beagle/beaglebone-black.cfg
board/ti_beaglebone.cfg board/beagle/beaglebone.cfg
interface/chameleon.cfg interface/parport/chameleon.cfg
interface/flashlink.cfg interface/parport/flashlink.cfg
}