according the RM0453, the second core have a different Flash CR and SR
registers for flash operations (called C2CR and C2SR).
so we need to a different flash_regs than older L4 devices.
@see stm32wl_cpu2_flash_regs
the C2CR register don't contain LOCK and OPTLOCK bits, and this explain
the addition of new register index called STM32_FLASH_CR_WLK_INDEX to
look-up the CR with lock, to be used in locking/unlocking the flash.
note: DBGMCU_IDCODE cannot be read using CPU1 (Cortex-M0+) at AP1,
to solve this read the UID64 (IEEE 64-bit unique device ID register)
Change-Id: Ifb6e291bf97f814f0b9987b2c40f3037959f7af4
Signed-off-by: Tarek BOCHKATI <tarek.bouchkati@gmail.com>
Reviewed-on: https://review.openocd.org/c/openocd/+/6050
Tested-by: jenkins
Reviewed-by: Oleksij Rempel <linux@rempel-privat.de>
Prerequisites:
The users of OpenOCD as well as computer programs interacting with OpenOCD are expecting that certain commands
do the same thing across all the targets.
Rules to follow when writing scripts:
1. The configuration script should be defined such as , for example, the following sequences are working:
reset
flash info <bank>
and
reset
flash erase_address <start> <len>
and
reset init
load
In most cases this can be accomplished by specifying the default startup mode as reset_init (target command
in the configuration file).
2. If the target is correctly configured, flash must be writable without any other helper commands. It is
assumed that all write-protect mechanisms should be disabled.
3. The configuration scripts should be defined such as the binary that was written to flash verifies
(turn off remapping, checksums, etc...)
flash write_image [file] <parameters>
verify_image [file] <parameters>
4. adapter speed sets the maximum speed (or alternatively RCLK). If invoked
multiple times only the last setting is used.
interface/xxx.cfg files are always executed *before* target/xxx.cfg
files, so any adapter speed in interface/xxx.cfg will be overridden by
target/xxx.cfg. adapter speed in interface/xxx.cfg would then, effectively,
set the default JTAG speed.
Note that a target/xxx.cfg file can invoke another target/yyy.cfg file,
so one can create target subtype configurations where e.g. only
amount of DRAM, oscillator speeds differ and having a single
config file for the default/common settings.
Tarek BOCHKATI
6c1e1a212a