The flag '-coreid' is used by the command 'target create' to
specify the debug controller of the target, either in case of a
single debug controller for multiple CPU (e.g. RISC-V harts) or
in case of multiple CPU on a DAP access port (e.g. Cortex-A SMP
cluster).
It is also currently used to specify the CPU ID in a SMP cluster,
but this is going to be reworked.
This flag has no effects on Cortex-M; ARM specifies that only one
CPU Cortex-M can occupy the DAP access port by using hardcoded
addresses.
The flash driver 'psoc6' uses the flag '-coreid' to detect if the
current target is the Cortex-M0 on AP#1 or the Cortex-M4 on AP#2
in the SoC.
There are other ways to run such detection, without using such
unrelated '-coreid' flag, e.g. using the AP number or the arch
type of the target.
Use the arch type to detect Cortex-M0 (ARM_ARCH_V6M) vs Cortex-M4
(ARM_ARCH_V7M).
Drop the flags '-coreid' from the psoc6 configuration file.
Change-Id: I0b9601c160dd4f2421a03ce6e3e7c55c6212f714
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
Reviewed-on: https://review.openocd.org/c/openocd/+/8128
Tested-by: jenkins
Reviewed-by: Tomas Vanek <vanekt@fbl.cz>
# SPDX-License-Identifier: GPL-2.0-or-later
Prerequisites:
The users of OpenOCD as well as computer programs interacting with OpenOCD are expecting that certain commands
do the same thing across all the targets.
Rules to follow when writing scripts:
1. The configuration script should be defined such as , for example, the following sequences are working:
reset
flash info <bank>
and
reset
flash erase_address <start> <len>
and
reset init
load
In most cases this can be accomplished by specifying the default startup mode as reset_init (target command
in the configuration file).
2. If the target is correctly configured, flash must be writable without any other helper commands. It is
assumed that all write-protect mechanisms should be disabled.
3. The configuration scripts should be defined such as the binary that was written to flash verifies
(turn off remapping, checksums, etc...)
flash write_image [file] <parameters>
verify_image [file] <parameters>
4. adapter speed sets the maximum speed (or alternatively RCLK). If invoked
multiple times only the last setting is used.
interface/xxx.cfg files are always executed *before* target/xxx.cfg
files, so any adapter speed in interface/xxx.cfg will be overridden by
target/xxx.cfg. adapter speed in interface/xxx.cfg would then, effectively,
set the default JTAG speed.
Note that a target/xxx.cfg file can invoke another target/yyy.cfg file,
so one can create target subtype configurations where e.g. only
amount of DRAM, oscillator speeds differ and having a single
config file for the default/common settings.
2fe392ef50