auracaster/sw_openocd
3
0
Fork 0
forked from auracaster/openocd
Code Pull Requests Activity

flash/startup: extend "program" command to accept "exit"

Browse Source 
This optional argument tells OpenOCD to exit after finishing (either
succesfully, or with an error) the programming sequence. Without it
OpenOCD stays running.

Change-Id: I6ecaf33ff985eea9a9cd02ff644a74403ae3e1e5
Signed-off-by: Paul Fertser <fercerpav@gmail.com>
Reviewed-on: http://openocd.zylin.com/2492
Tested-by: jenkins
Reviewed-by: Uwe Bonnes <bon@elektron.ikp.physik.tu-darmstadt.de>
Reviewed-by: Spencer Oliver <spen@spen-soft.co.uk>
This commit is contained in:
Paul Fertser
2015-01-23 11:38:31 +03:00
committed by Andreas Fritiofson
parent a35712a85c
commit 30f802493d
2 changed files with 28 additions and 18 deletions
Download Patch File Download Diff File Expand all files Collapse all files

10
doc/openocd.texi
View File

@@ -4922,7 +4922,7 @@ comamnd or the flash driver then it defaults to 0xff.
@end deffn
@anchor{program}
@deffn Command {program} filename [verify] [reset] [offset]
@deffn Command {program} filename [verify] [reset] [exit] [offset]
This is a helper script that simplifies using OpenOCD as a standalone
programmer. The only required parameter is @option{filename}, the others are optional.
@xref{Flash Programming}.
@@ -5928,7 +5928,7 @@ Programming can be acheived by either using GDB @ref{programmingusinggdb,,Progra
or using the cmds given in @ref{flashprogrammingcommands,,Flash Programming Commands}.
@*To simplify using the flash cmds directly a jimtcl script is available that handles the programming and verify stage.
OpenOCD will program/verify/reset the target and shutdown.
OpenOCD will program/verify/reset the target and optionally shutdown.
The script is executed as follows and by default the following actions will be peformed.
@enumerate
@@ -5937,7 +5937,7 @@ The script is executed as follows and by default the following actions will be p
@item @code{flash write_image} is called to erase and write any flash using the filename given.
@item @code{verify_image} is called if @option{verify} parameter is given.
@item @code{reset run} is called if @option{reset} parameter is given.
@item OpenOCD is shutdown.
@item OpenOCD is shutdown if @option{exit} parameter is given.
@end enumerate
An example of usage is given below. @xref{program}.
@@ -5946,11 +5946,11 @@ An example of usage is given below. @xref{program}.
# program and verify using elf/hex/s19. verify and reset
# are optional parameters
openocd -f board/stm32f3discovery.cfg \
-c "program filename.elf verify reset"
-c "program filename.elf verify reset exit"
# binary files need the flash address passing
openocd -f board/stm32f3discovery.cfg \
-c "program filename.bin 0x08000000"
-c "program filename.bin exit 0x08000000"
@end example
@node NAND Flash Commands