### Introduction ### The following firmware binaries allow to use the nRF5340-DK as a HCI UART Controller 5.2+ with enabled Flow Control. ### Programming ### Before using the nRF53 programm nRF53DK_hci_uart.hex on the board (e.g. using nRF Connect for Desktop): ### UART Configuration ### In order to use UART with Flow Control enabled the FLOW CONTROL switches for VCOM0 and VCOM1 must the set to OFF. The UART runs with following configuration: - BAUDRATE = 1000000 - FLOWCONTROL = enabled - DATA = 8 bits - STOP = 1 bit - PARITY = None When the DK is connected to the PC via USB two VCOM Ports are created (e.g. COM5 and COM6). Please use com port with the lower number.