Move the ti targets to a TI folder. Since the folder is ti, we can
drop the "ti" prefix from the files themselves.
Done via the following script:
mkdir target/ti
FILES=`ls target/ti*.cfg target/omap*.cfg target/am335x.cfg
target/amdm37x.cfg target/icepick.cfg target/stellaris.cfg
target/davinci.cfg`
for cname in $FILES
do
bname=`basename $cname`
nname=`echo $bname|sed -e "s/^ti-//g"|sed -e "s/ti_//g"`
npath="target/ti/$nname"
echo "$cname => $npath"
fref=`git grep $cname .|cut -d ':' -f1|sort -u`
sed -i -e "s&$cname&$npath&g" $fref
git mv $cname $npath
done
Change-Id: I9f94dc6bb01f73721d4ff96be92cb51de2cbf0e2
Suggested-by: Antonio Borneo <borneo.antonio@gmail.com>
Signed-off-by: Nishanth Menon <nm@ti.com>
Reviewed-on: https://review.openocd.org/c/openocd/+/9203
Tested-by: jenkins
Reviewed-by: Antonio Borneo <borneo.antonio@gmail.com>
# SPDX-License-Identifier: GPL-2.0-or-later
Prerequisites:
The users of OpenOCD as well as computer programs interacting with OpenOCD are expecting that certain commands
do the same thing across all the targets.
Rules to follow when writing scripts:
1. The configuration script should be defined such as , for example, the following sequences are working:
reset
flash info <bank>
and
reset
flash erase_address <start> <len>
and
reset init
load
In most cases this can be accomplished by specifying the default startup mode as reset_init (target command
in the configuration file).
2. If the target is correctly configured, flash must be writable without any other helper commands. It is
assumed that all write-protect mechanisms should be disabled.
3. The configuration scripts should be defined such as the binary that was written to flash verifies
(turn off remapping, checksums, etc...)
flash write_image [file] <parameters>
verify_image [file] <parameters>
4. adapter speed sets the maximum speed (or alternatively RCLK). If invoked
multiple times only the last setting is used.
interface/xxx.cfg files are always executed *before* target/xxx.cfg
files, so any adapter speed in interface/xxx.cfg will be overridden by
target/xxx.cfg. adapter speed in interface/xxx.cfg would then, effectively,
set the default JTAG speed.
Note that a target/xxx.cfg file can invoke another target/yyy.cfg file,
so one can create target subtype configurations where e.g. only
amount of DRAM, oscillator speeds differ and having a single
config file for the default/common settings.
2f8ddc0835